“Rebuild versus Replace”
At ECCO Machinery our goal is to assist you with your machinery needs. Sometimes the best approach is to rebuild your existing machine, instead of buying a new or used one.
We start by determining what the best route is to rebuild your current machine. After determining what needs to be replaced/repaired/rebuilt we outsource quality components and the goal is to get your machine back to its optimum performance.
Our shop rate is $125/hr.
Rebuild possibilities:
- Clean-up only: The machine is partially disassembled, parts are cleaned-up; machine is re-assembled to the same condition it arrived. A detailed report is created of any potential parts or components that need to be replaced.
- Clean-up & Parts Replacement: The machine is partially or completely disassembled, parts are cleaned-out, worn-out components are outsourced and replaced; machine is re-assembled to the same condition it arrived. A detailed report is created of all parts or components that have been replaced.
- Clean-up, Parts Replacement and Paint Job: The machine is partially or completely disassembled, parts are cleaned-out, worn-out components are outsourced and replaced; machine is re-painted to match original colour. It is then re-assembled to the same condition it arrived. A detailed report is created of all parts or components that have been replaced.
- Electrical Upgrades: CSA or Electrical Provincial Certification is mandatory in Canada. All electrical systems are fully inspected and replaced with CSA approved components. A detailed report is created of all parts or components that have been replaced.
- Safety Upgrades: Everyone is worried about safety. We outsource and install safety guards and safety upgrades to any machinery.
- Motor Replacement: If your machine has a burned out motor, we can replace it with a brand new one and make sure it is installed properly and as per CSA standards.